The weld on frame reinforcements in the kit are to add additional strength to the factory bumper mounting points which are susceptible to bending during winching/recovery operations.
--Made 3/16” thick plate
--Kit includes 2 plates and ½” grade 8 hardware.
Step 1- Remove your factory bumper cover or aftermarket bumper.
Step 2- Remove the factory aluminum crash bar if present.
Step 3- Use an angle grinder with a cutoff wheel or similar implement to cut the factory studs off.
Step 4- Use a 9/16” drill bit to widen the holes to allow for installation of new ½” hardware.
Step 5- Thread new ½” hardware in from behind factory plates and install the reinforcement plates, snugging up the bolts so the plate doesn’t move.
Step 6- Weld the bolts to the back of the factory plate then weld the reinforcement plate to the factory plate.
Step 7- Remove the temporary nuts and reinstall your bumper.
Now you’re ready to winch without fear of bending.